Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for ITech IT-E154
Summary of Contents for ITech IT-E154
- Page 1 19-inch Rack IT-E154 User Manual...
- Page 2 Notices Warranty Safety Notices © Itech Electronic, Co., Ltd. 2019 The materials contained in this No part of this manual may be document are provided “as is”, and reproduced in any form or by any means is subject to change, without prior ( including electronic storage and notice, in future editions.
-
Page 3: Warranty
Warranty ITECH warrants that the product will be free from defects in material and workmanship under normal use for a period of one ( 1) year from the date of delivery ( except those described in the Limitation of Warranty below). -
Page 4: Waste Electrical And Electronic Equipment ( Weee) Directive
IT-E154 User Manual A chassis terminal Regulatory Markings The CE mark indicates that the product complies with all the relevant European legal directives. The specific year ( if any) affixed refers to the year when the design was approved. The instrument complies with the... -
Page 5: Compliance Information
IT-E154 User Manual Compliance Information Complies with the essential requirements of the following applicable European Directives, and carries the CE marking accordingly: Electromagnetic Compatibility (EMC) Directive 2014/30/EU Low-Voltage Directive (Safety) 2014/35/EU Conforms with the following product standards: EMC Standard IEC 61326-1:2012/ EN 61326-1:2013 ¹... -
Page 6: Table Of Contents
ARKINGS ( WEEE) D ............ASTE LECTRICAL AND LECTRONIC QUIPMENT IRECTIVE .......................... OMPLIANCE NFORMATION CHAPTER1 IT-E154 INTRODUCTION ...................... 1 CHAPTER2 MOUNTING INSTRUMENT ....................4 2.1 P ............................4 REPARATION 2.2 M ......................4 OUNTING A INGLE NSTRUMENT 2.3 M ....................... 8... -
Page 7: Chapter1 It-E154 Introduction
IT-M series power supply or regenerative source and load system are compatible with a standard 19-inch cabinet. For installation, ITECH provides with a specially designed rack mount kit IT-E154 series, this series rack mount kit includes IT-E154A/IT-E154B/IT-E154C. User can select different model according to requirement. - Page 8 IT-E154 User Manual IT-E154C IT-E154C rack is a set of rack mount kit spare parts. If the 19-inch cabinet has no tray, the user can select the IT-E154C rack kit to fix the rear end of the IT-M series instrument on the cabinet. IT-E154C cannot be used independently, and needs to be fixed together with IT-E154A or IT-E154B.
- Page 9 IT-E154 User Manual 版权所有 © 艾德克斯电子有限公司...
-
Page 10: Chapter2 Mounting Instrument
Chapter2 Mounting Instrument 2.1 Preparation Before installing any IT-E154 rack mount kit, it is necessary to remove the side footing of the instrument. Use a screwdriver to loosen the two screws for fixing the side footing, and remove the side footing. As shown in the figure below, remove four side footings at the front, rear, left and right of the instrument. - Page 11 IT-E154 User Manual The effect picture after mounting is as shown below. The dimensions after mounting are as shown below (Unit: mm).
- Page 12 IT-E154 User Manual Cabinet without a tray If the 19-inch cabinet has no tray, to mount a single set of instrument into the cabinet, it is necessary to mount the IT-E154B rack kit at the front of the instrument, and mount the IT-E154C kit at the rear of the instrument to fix the rear part of the instrument on the cabinet.
- Page 13 IT-E154 User Manual The effect picture after mounting is as shown below. The user may install the rack-mounted instrument on a standard 19-inch cabinet. The dimensions for rack-mounted instrument are as shown below. (Unit: mm)
-
Page 14: Mounting Two Instruments
IT-E154 User Manual 2.3 Mounting Two Instruments Cabinet with a tray If the 19-inch cabinet has a tray, to mount two sets of instruments into the cabinet, it is only necessary to mount the IT-E154A rack kit. The mounting operation steps are as shown below. - Page 15 IT-E154 User Manual The user may install the two rack-mounted instruments into a standard cabinet. The dimensions for rack-mounted instrument are as shown below. (Unit: mm)
- Page 16 IT-E154 User Manual Cabinet without a tray If the 19-inch cabinet has no tray, to mount two sets of instruments into the cabinet, it is necessary to mount the IT-E154A rack kit at the front of the instruments, and mount the IT-E154C kit at the rear of the instruments to fix the rear parts of the instruments on the cabinet.
- Page 17 IT-E154 User Manual Based on the steps shown below, combine two sets of instruments mounted with left and right rack accessories. Use screws to fix the front and rear ends of the two sets of instruments from up to down.
- Page 18 IT-E154 User Manual The user may install the rack-mounted instrument into a standard cabinet. The dimensions for rack-mounted instrument are as shown below. (Unit:...
- Page 19 Contact US Thank you for purchasing ITECH products. If you have any doubt about this product, please contact us as follows. 1. Please refer to the CD-ROM of related user’s manual in package. 2. Visit ITECH website www.itechate.com . 3. Select the most convenient contact for further consultation.
Need help?
Do you have a question about the IT-E154 and is the answer not in the manual?
Questions and answers