Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Asus RX3041
Summary of Contents for Asus RX3041
- Page 1 RX3041&SL200 Internet Connection Configuration Guide V1.0...
-
Page 2: Table Of Contents
Contents Introduction........................1 Chapter 1: Connecting the router...................1 Chapter 2: Getting to know Internet connection type............1 Chapter 3: Configuring the router..................2 3.1 Enter into router’s Web-based configuration page ..........2 3.2 WAN Connection Type ---- Dynamic IP............3 3.3 WAN Connection Type ---- Static IP ..............4 3.4 WAN Connection Type ---- PPPoE..............5 3.5 WAN Connection Type ---- PPTP/L2TP............6 3.6 WAN Connection Type ---- BigPond. -
Page 3: Introduction
Introduction This document describes how to set up ASUS RX3041/SL200 for getting connection to the Internet and provides troubleshooting tips to help you fix some simple problems. Chapter 1: Connecting the router The figure below illustrates a connection diagram example. -
Page 4: Chapter 3: Configuring The Router
only. In this type, you should have IP address, Subnet mask, Default Gateway, Username and Password from your ISP. BigPond is a service used in Australia only. If you are using a Bigpond connection, check with your ISP for the necessary setup information. Chapter 3: Configuring the router 3.1 Enter into router’s Web-based configuration page Open browser and type router’s IP address:... -
Page 5: Wan Connection Type
3.2 WAN Connection Type ---- Dynamic IP Click WAN Connection, Select WAN Connection Mode as Dynamic IP Address. MAC Cloning is optional as your ISP request. If it’s necessary, please enable the MAC Cloning and fill the MAC of your PC in MAC Address field. Click Clone MAC button will clone the MAC of current PC automatically. -
Page 6: Wan Connection Type
3.3 WAN Connection Type ---- Static IP Click WAN Connection, Select WAN Connection Mode as Static IP Address. Configure Static IP Address Input IP Address, Subnet Mask, ISP Gateway provided by your ISP. MAC Cloning is optional as your ISP request. If your ISP provides more IP addresses, please select Yes for enabling more IP addresses, and fill More IP Addresses, then click Add button. -
Page 7: Wan Connection Type
Click Status will show WAN information. 3.4 WAN Connection Type ---- PPPoE Click WAN Connection, Select WAN Connection Mode as PPPoE. Configure “PPPoE Account” Input Username, Password provided by your ISP Then click OK to save and apply the setting. Click Continue back to configuration page. -
Page 8: Wan Connection Type
Check if the WAN interface gets a dynamic IP address and related information. Click Status will show WAN information. 3.5 WAN Connection Type ---- PPTP/L2TP Click WAN Connection, Select WAN Connection Mode as PPTP. Select WAN Interface IP Dynamic IP Select WAN Interface IP Static IP, fill IP address, Subnet Mask, Gateway that provided by your ISP. - Page 9 Configure PPTP Account and PPTP Password provided by ISP. And Select the PPTP Gateway type and fill the gateway info. Connection ID is optional as your ISP request. Then click OK to save and apply the setting. Check if the WAN interface gets a dynamic IP address and related information. Click Status will show WAN information.
-
Page 10: Wan Connection Type
3.6 WAN Connection Type ---- BigPond a) If you are using a BigPond connection, check with your ISP for the necessary setup information. b) Click WAN Connection, Select WAN Connection Mode as Dynamic IP Address, and enable BigPond. Fill the User Name, Password and Authentication Server in proper field. - Page 11 • For each powered on computer connected to the router with a securely plugged in network cable, the corresponding LAN port status indicator will light up. The front panel of the router identifies the number of each LAN port. Make sure the network settings of the computer are correct. •...