Cisco 6000 Series Hardware Installation Manual page 13

Installation Roadmap
Table 1-1
for operation. Use this table as a checklist to ensure that all components are properly installed in the
correct order. For information about a step, see the respective section of this installation guide.
Table 1-1
Step
Verify that the chassis is securely bolted to the floor.
1.
2. Ground the chassis.
Install the external cosmetics on the front of the chassis.
3.
Install the external cosmetics on the rear of the chassis.
4.
Install either AC or DC input power connections to the power
5.
trays.
6. Install power modules in the power trays.
OL-29234-02
lists the steps to install the Cisco NCS 6008 chassis and its components and prepare the system
Overview of Installation Steps
Cisco Network Convergence System 6000 Series Routers Hardware Installation Guide
1
C H A P T E R
See
Cisco Network
Convergence System
6000 Series Routers
Unpacking, Moving,
and Securing Guide
"Installing the Chassis
Ground Cable" section
on page 4-12
"Installing the Front
Exterior Cosmetics"
section on page 3-4
"Installing the Rear
Exterior Cosmetics"
section on page 3-11
"Installing AC Input
Power Cords" section
on page 4-25
"Installing DC Input
Power Cables" section
on page 4-26
"Installing an AC or DC
Power Module" section
on page 4-19
Check
or
1-1