Advertisement
Troubleshooting Guide
PROBLEM
Water droplets drip on the
fabric during ironing
The iron produces little or no
steam
Flakes and white impurities
come out of the soleplate
during ironing
The spray function or the steam
shot do not work properly
Soleplate is not heating up
The temperature control LED
turns permanently on in red
colour
Water droplets drip from the
soleplate after the iron has
been unplugged or has been
stored
10
SI 50xx
Press the water tank lid and check if it is closed
Check that the temperature
selector is at least on ••. Select a
higher temperature setting. Take
longer intervals when pressing
the steam shot button.
If chemicals have been put into the water tank, empty the water tank,
Check water level and refi ll tank
Check that the temperature
selector is at least on ••.
Check if steam selector is set on a steam setting
Perform the descaling procedure
Unplug the iron and plug in again.
Rotate the temperature selector
from «min» to «max». Then select
the desired temperature.
n/a
Set the steam regulator to «
Empty the water tank after ironing and place the iron vertically on a
stable surface during cooling down
SOLUTION
Take longer intervals when pressing
the steam shot button.
rinse it 2-3 times.
Perform descaling procedure
Wait until the iron heats up and
the temperature control LED is
permanently ON.
Refi ll the water tank
Unplug the iron and plug in again.
Unplug the iron and plug in again.
If the problem does not disappear
contact the Braun customer service.
SI 51xx
»
Advertisement
