TomTom Rider Manual page 4

(7) It is a good idea to repeat this process whilst wearing the Schuberth helment to ensure
announcements are nice and clear. If they are muffled then you may need to adjust the speaker
placement within the helmet lining so they align with your ears.
nd
(8) You may also want to adjust the volume on the Tomtom Rider 2 Edition to the maximum
loudness level – and then reduce the sound to a suitable level using the volume Up/Down buttons on
the SRC collar as needed. This will ensure that even when travelling very quickly you should be able
nd
to clearly hear messages from the TomTom Rider 2 Edition or any audio inputs being routed via the
TomTom such as bluetooth Phone or MP3 inputs.
IF THE PAIRING FAILS...
OK it is possible that the pairing process may fail. In which case the important thing to stress is that
over time Schuberth/Scala have enhanced their equipment, via software updates to work with newer
equipment, made to newer bluetooth standards.
nd
Sadly the software for the Rider 2 Edition remains pretty ancient meantime Schuberth/Scala have
actively released software updates to ensure the SRC system can communicate with newer
TOMTOM and Garmin GPS units. Unfortunately these update have resulted in some of the oldest
GPS bluetooth protocols being removed.
So if you encounter the ""the required features cannot be found" message, your first step should be to
completely reset the SRC to force it to revert to the original SRC software which should be recognised
nd
by the Rider 2 Edition.
Please note this will clear ALL existing bluetooth links from the SRC so you may need to
subsequently pair any mobile phones or other bluetooth connections. BUT, when it comes to
nd
connecting a TomTom Rider 2 Edition, ALWAYS sort out that connection first.
To reset a SRC which DOES NOT have A&B buttons – just start the SRC, when the blue lights are
flashing slowly press and hold the "+" (volume up) button for 5 seconds until red/blue flashing starts
Then press the "play music/telephone" button for 2 seconds until the LED flashes 5 times in Purple
and then the SRC will turn off. This will reset the SRC and when restarted it should be able to pair
nd
with a TomTom Rider 2 Edition using the relevant process outlined above.
To reset a SRC which DOES have A&B buttons – just start the SRC, when the blue lights are flashing
slowly, press and hold down the "mobile phone" button for at least 6 seconds until the red/blue
flashing starts.
Then press the "volume up" button for 3 seconds until the red and blue LEDs blink 5 times and then
the SRC will turn off. This will reset the SRC and when restarted, it should be able to pair with a
nd
TomTom Rider 2 Edition using the relevant process outlined above.