Configuring Cisco® Router
Appendix D – Broadband Router and Network
Configuring Cisco
To configure the Cisco Router (Q13708-08B), proceed as follows:
Ensure the router is powered up by verifying that the System LED is illuminated.
1
Press and hold the Reset button for 30 seconds. The button can be found on the back of the
2
router, to the left of port 1.
3
After 10 seconds, the Diag LED will begin flashing slowly. After 30 seconds the Diag LED
will begin flashing quickly. Release the Reset button once the Diag LED is flashing quickly.
The Diag LED will continue flashing and turn solid when the reset is complete.
4
The router is now reset to Cisco factory defaults.
Cisco Factory Default Settings
Parameter
Username:
Password:
LAN IP:
DHCP Range: 192.168.1.100 to 149
Netmask
Figure D-1: Cisco Factory Default Setting Screen
MDE-4699L Applause™ Media System Installation, Service, and Parts Manual · June 2017
Configuration
Router
®
Default Value
admin
admin
192.168.1.1
255.255.255.0
Broadband Router and Network Configuration
Page D-1