Table of Contents
Advertisement
Quick Links
Bistro Counter Height or Bar Height Table
Tools Not Included but Required:
wrench that will accept a 1/4" hex drive bit.
Tools Included:
Assembled Leg Sets
1. Position the leg sets upside down with the feet in the air and the leg notches facing inward. Place a leg
brace into one of the lower notches of both leg sets. Screw in a 3" lag screw only part way, into both let sets.
Repeat this step and insert the other leg brace into the other lower set of notches. Screw in a 3" lag screw
only part way into both let sets.
Step 1a
2. Repeat step 1 and insert the upper braces. After inserting all 4 braces, tighten all screws.
ASSEMBLY INSTRUCTIONS
4mm Allen Wrench
Leg Braces
Hardware
7/ 1 6" wrench, either a power tool, hand driver or ratchet
Parts Included:
2 - Assembled Leg Sets
1 - Table Top
1 - Hole Plug
4 - Leg Braces
Step 1b
Stainless Steel
Hardware Included:
8 - 3" Lag Screws
8 - 1-1/2" Screws
8 - Washers
Table Top
Hole
Plug
Advertisement
Table of Contents
Related Manuals for Perfect Choice Bistro Counter Height or Bar Height Table
Summary of Contents for Perfect Choice Bistro Counter Height or Bar Height Table
- Page 1 ASSEMBLY INSTRUCTIONS Bistro Counter Height or Bar Height Table Tools Not Included but Required: 7/ 1 6" wrench, either a power tool, hand driver or ratchet wrench that will accept a 1/4" hex drive bit. Tools Included: 4mm Allen Wrench...
- Page 2 3. Lay the tabletop upside down on the floor. Step 3 Place your assembled leg section (with the feet still in the air) on the tabletop. Step 4 4. Line up the 4 holes on both sides of the table. Place a washer and a 1-1/2" pan head screw into each hole and then tighten all 8 screws.
Need help?
Do you have a question about the Bistro Counter Height or Bar Height Table and is the answer not in the manual?
Questions and answers