Table of Contents
Advertisement
Manual Lens
Remove Lens
•
When it is ∞, you can turn the ADJUST screw to adjust the focus circle to
adjust the focal distance.
Install C type lens
•
Remove the CCD protection cap; use the cross-head screwdriver to
remove the screw near the focal circle. Then please turn counter clockwise
to move the focal circle out for several millimeters. Now you can focus
manually.
•
Then please use the cross-head screwdriver to fix the screw back firmly.
Secure the focal circle.
•
Install the C/CS adapter to the camera.
•
Finally, line up lens to the proper installation. Turn clockwise to fix the lens
firmly.
Install CS type lens
•
Remove the CCD protection cap; use the cross-head screwdriver to
remove the screw near the focal circle. Then please turn counter clockwise
to move the focal circle to the end and now you can focus manually.
•
Then please use the cross-head screwdriver to fix the screw back firmly.
Secure the focal circle.
•
Finally, line up lens to the proper installation. Turn clockwise to fix the lens
firmly.
Figure 3-2 Lens installed
Please follow the steps listed below to remove lens. The interface is shown as
in
Figure
3-3.
•
Turn the lens counter clockwise and then remove it from the camera.
Honeywell
9
Advertisement
Table of Contents
