Sargent ASSA ABLOY 3727 Series Instructions For Installing

US PATENT NO. 268003
CANADIAN PATENT NO. RD1981
CAUTION: BEFORE STARTING
• DOOR SHOULD BE FITTED AND HUNG
• CHECK BOX LABEL FOR HAND AND SIZE OF EXIT DEVICE
AVAILABLE STOCK LENGTHS
32" DOOR. CAN BE CUT TO FIT 24" DOOR.
LENGTH E
36" DOOR. CAN BE CUT TO FIT 30" DOOR.
LENGTH F
48" DOOR. CAN BE CUT TO FIT 36" DOOR.
LENGTH G
Top rod
Horizontal reference line
(C L of chassis and rail assembly)
Bottom
cover
Bottom
rod
Adjustment
pin
Bottom
case
2. PREPARE DOOR
TAPE TEMPLATES ON INSIDE OF DOOR ALONG
REFERENCE LINES WITH SUPPLIED TAPE
IF DOOR ALREADY HAS ANSI DOOR PREP (161 CUT-OUT) OR HAS
2-1/8" DIA. HOLE AT 2-3/4" BACKSET, POSITION TEMPLATE OVER EXISTING
HOLE AND SPOT AND DRILL HOLES
Top case
template
Horizontal reference line
(C L of chassis and rail assembly)
Vertical reference line
(C L of chassis)
Top case
Adjustment pin
Top cover
Guide
Center chassis
assembly
Guide
1.
Door stop
ANSI A156.2 series cross bore hole
when knob rim or lever handle trim
is used
INSTRUCTIONS FOR INSTALLING
3727 / NB3727 SERIES
VERTICAL ROD EXIT DEVICE
FOR ASSISTANCE, CONTACT SARGENT AT 800-727-5477 or www.sargentlock.com
THIS EXIT DEVICE IS HANDED
OUT
RIGHT HAND LEFT HAND
REVERSE BEVEL REVERSE BEVEL
Lockdown
button
Rail assembly
"Lockdown key"
To operate:
Depress pushrail; insert hex key
and turn
MARK VERTICAL AND HORIZONTAL
REFERENCE LINES ON DOOR
Horizontal reference line
(C L of chassis and rail assembly)
Vertical reference line
(C L of chassis)
FINISHED FLOOR
APPLY HARDWARE
3.
FOR LEVER TRIM APPLICATIONS
SEE SEPARATE INSTRUCTION SHEET PACKED WITH TRIM
NOTE: FOR EXIT APPLICATIONS ONLY
REMOVE AND DISCARD CAM FROM
CENTER CHASSIS FOR FLUSH
MOUNTING. ATTACH CHASSIS WITH
FOUR (4) #10 WOOD OR MACHINE
SCREWS.
Copyright © 2003, 2008, 2012, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Sargent Manufacturing Company is prohibited.
Mounting plate
Lift
lever
pin
Lift
lever
ALL 3727 SERIES EXIT DEVICES
ARE HANDED AND REVERSIBLE. NORMALLY ASSEMBLED FOR
A LEFT HAND REVERSE BEVEL DOOR AT THE FACTORY.
TO CHANGE HAND OF 3727 EXIT DEVICE:
1. USE 2-1/4" PIN (SUPPLIED IN SCREW PACK) TO PUSH OUT
LIFT LEVER PIN.
2. REMOVE LIFT LEVER. INVERT AND REASSEMBLE WITH LIFT
LEVER PIN AS SHOWN.
DETERMINE DIMENSION "A"
- IF LOCK STILE IS APPROX. 4-1/2"
WIDE OR WIDER, DIM. A = 2-3/4"
- IF LOCK STILE IS LESS THAN 4-1/2"
WIDE, DIM. A = 1/2 OF THE VISIBLE
41"
WIDTH OF THE LOCK STILE (WHEN
DOOR IS CLOSED AGAINST STOP)
Refer to template to locate
horizontal reference line
End cap
2-1/4" long pin
Door
Dim "A"
Vertical reference line
(C L of chassis)
Center
chassis
cam
Cam
A7425F