Table of Contents
Advertisement
WARNING: ALWAYS DISCONNECT THE PLUG FROM THE POWER SUPPLY BEFORE ANY
MAINTENANCE IS STARTED.
1. WATER FILTER: Inspect the water filter. Clean water filter if it is dirty.
2. NOZZLE CLOGGED
this happens turn unit off and unplug portable washer:
1)
Unplug power supply, pull trigger on spray nozzle handle to relieve pressure, remove
nozzle from hose.
2)
Clean the spray nozzle with the nozzle cleaning tool.( See steps 1&2 below).
3)
Flush wand assembly backwards with water or compressed air.
4)
If pressure is still too high, repeat steps 1-2.
3. LUBRICATION: No lubrication is required for this pump. Silicone grease may be added to
hose connector o-rings if connecting becomes difficult.
WARNING: HIGH PRESSURE HOSE, DAMAGED HIGH PRESSURE HOSES CAN BURST
AND CAN CAUSE A POTENTIALLY HAZARDOUS SITUATION OR INJURY. HIGH
PRESSURE HOSE SHOULD NOT BE KINKED, CRUSHED, TWISTED, OR DAMAGED IN
ANY WAY. REPLACE THE HIGH PRESSURE HOSE SHOULD THIS OCCUR.
TO CLEAN SPRAY NOZZLE
STEP 1:
Disconnect the spray nozzle Clean the nozzle with the tool.
From the hose by whirling
the joint from right to left.
The way to fold the bucket: Hold the bucket on, turn the bucket from right to left by the handle,
press it down when turning.(fold the bucket while it as dry as possible.)
o not fill the folding bucket with anything but clear water（0°C to 60°C） 。
Warning: D
GENERAL MAINTENANCE
:
A clogged nozzle will cause the operating pressure to be too high. If
STEP 2:
Remove any dirt from the nozzle Discard and replace with
and rinse.
REPLACE FUSE
Unscrew end of power cord
Adaptor to remove old fuse.
New fuse.
10
Advertisement
Table of Contents
