How To Operate - Pyle PCRWASH18 Owner's Manual

IMPORTANT: MUST READ ALL OPERATING INSTRUCTIONS PRIOR TO FIRST USE.
IMPORTANT: DISCONNECT THE POWER CABLE WHENEVER ENGINE IS TURNED OFF
FOR EXTENDED PERIODS OF TIME. THE POWER DOES NOT TURN OFF
AFTER SWITCHING OFF THE ENGINE IN SOME CARS. IF THE POWER
PLUG IS LEFT CONNECTED, THE BATTERY MAY BECOME RUN DOWN
OR DAMAGED.
Plug into car cigarette lighter or power port.
:
NOTE Some vehicles require that ignition be in accessory position.
(Diagram 1)
PURGE AIR FROM SYSTEM: To purge air, turn unit on (Diagram 1). Point nozzle and squeeze
lever until steady stream of water exits hose (Diagram 2).
With normal use, air can get trapped in the hose. We recommend the following steps to purge
the air out of your system and get the maximum amount of pressure out of your new car washer.
FOLLOW THESE STEPS AFTER EACH TIME YOU REFILL YOUR FOLDING BUCKET:
1. Fill the folding bucket with water.
2. Connect the hose to the unit.
3. Direct the hose. Without the nozzle attached, into the bucket.
4. Turn the power on and run for approximately 30 seconds or until a steady stream of water is
present.
5. Turn off the power.
6. Connect the nozzle to the hose.

HOW TO OPERATE

(Diagram 2)
8