Service Mode - Panasonic HDC-SD80P Service Manual

6 Service Mode

1. Indication method of the service menu
Set the mode switch "Motion Picture Recording" mode.
2. While the power is turned OFF, keep pressing the "Power" button, "Zoom lever" to W side and "intelligent auto/Manual" button
for more than 3 seconds until the top screen of the Service Mode Menu being displayed.
Service mode menu
Screen display
1
3
4
5
10
11
12
NOTE:
Do not using service mode except above table of Service mode menu.
3. End method of the top screen of the service mode menu
Touch the [ EXIT ] of LCD to end the service mode, and then POWER OFF.
Contents
Factory settings
Built-in memory self check execution
(HDC-TM80 only)
Lock search history indication
Power ON self check result display
Erasing the lock histories
Erasing the internal media
management information
Camera data indications while the
video playback
Function
Function to throw a product up in a factory shipment state
(When recorded data in Built-in memory, "error display" is done)
Function to check self as for the state of Built-in memory
Display the camera system error cord for three histories saved
in EEPROM
Power ON self check (function to diagnose correct function of
the device and interface between devices) result display
Erasing the error histories (working time is not erased)
Erasing the internal media management information for fast
boot stored in IC3402(flash memory)
Display the camera informations (Shutter speed, Iris value,
White balance and focal length) while playing recorded video
16