Table of Contents
Advertisement
Water
Detergent
Disinfectant
4.4
Drying
1) Wipe the probe with a single-use, fluff-free
wipe or towel to remove moisture from the surface of the probe.
2) Dry the probe naturally in an ambient temperature between
15-30°C for a minimum of 4 hours. Alternatively the equipment
can be dried using a drying heater at a temperature of less
than 60°C.
4.5
Inspection
Inspect the equipment for any damage such as crack, scratch or
deformation. Do not use it if any damage is found.
Fig.3 Immersion of the probe
-9-
Drying
Q1E-EP0659
Advertisement
Table of Contents
