Slide Hammer Kit - jcb 540-170 Service Manual

The slide hammer kit is used to remove pivot pins that
must be extracted, i.e. cannot be 'knocked through'. The
purpose of this description is to explain how the kit and the
various components are used to remove the pivot pins.
The adaptors 69-A that form part of the kit have a screwed
thread at each end. One of the threads will always be M20
size, this is to accommodate the end stops, items 69-B and
69-C. The other end of the adaptor will have varying thread
sizes to suit the different size of threads in the pivot pins.
Fitting Procedure
1 Prepare the pivot pin, for instance, if fitted, remove
the pivot pin retaining bolt.
2 Determine the thread size of the pivot pin and then fit
the appropriate adaptor 69-A as shown. Use the
spanner flats 69-D to securely fit the adaptor.
1-5-25
Section 1-5 - General Information

Slide Hammer Kit

TB-003
Fig 69. Typical M/c. Installation
3 Fit an end stop 69-B onto the other end of the adaptor
(M20 thread size), make sure that the adaptor
threads are fully engaged.
4 Fit the 'slide bar' 69-E into the end stop. Again make
sure that the threads are fully engaged.
5 Fit the 'slide hammer', item 69-F, onto the slide bar as
shown.
6 Finally, fit another end stop, item 69-C, at the end of
the slide bar, as shown. The slide hammer kit is now
ready to use.
7 To extract the pivot pin, slide the hammer along the
bar until it contacts end stop 69-C. Repeat this step
until the pivot pin is released.
8 To remove the slide hammer kit, reverse steps 2 to 7.
9803/3750-05 (1-06-00)
Service Tools
Slide Hammer Kit
1-5-25