Service & Maintenance Instructions - Salsco Electric Greens Roller QC Operator And Parts Manual

SERVICE & MAINTENANCE INSTRUCTIONS
1. Check all grease fittings as listed below on a WEEKLY basis, and grease as necessary. (Add
grease till grease leaks slightly from fitting.)
 Bearings on roll housings - Quantity 4
 Pivot bearing on main housing - Quantity 2
 U-Joint on steering shaft - Quantity 1
2. After approximately 1 WEEK of use, and then every 2 WEEKS thereafter, check drive
chains - one on each side on roller drive motor. Pivot motor to tighten chain. NOTE: Check
and adjust the tension of both drive motor chains on a regular basis. If chains are not tight,
this could cause severe sprocket wear and possible breakage.
3. After approximately 1 WEEK of use, and then every 2 WEEKS thereafter, check chains
on steering. Adjust as needed.
4. Pivot for articulating steering should be tight, with no play, much the same as wheel bearings
on cars.
5. Keep unit clean. Should rust form on rolls, simply drive the unit on a rough area till rolls are
clean.
6. Battery Maintenance/Charging. SEE MATERIALS/MANUAL PROVIDED BY
TROJAN, ENCLOSED IN THE MANUAL PACKAGE YOU RECEIVED WITH THE
ROLLER.
SAFETY IS A PRIME CONCERN AT SALSCO AND THE SAFETY DECALS ON YOUR MACHINE
ARE A HIGHLY VISIBLE AND CONSTANT REMINDER TO ALL OPERATORS. REPLACEMENT
SAFETY DECALS MAY BE OBTAINED BY CALLING SALSCO @ 1-800-872-5726, OR THE
DEALER IN YOUR AREA.
"O" MANUALS; EGR_QC_0009074 _Manual PW_10.30.2017.doc
6