Advertisement
Quick Links
1825 VIA BURTON
ANAHEIM CA 92806
714-772-5202 / FAX 714-772-2302
EMAIL: MAIL@MAJORMFG.COM
WEB: WWW.MAJORMFG.COM
INSTRUCTIONS
FOR HIT-40AR4
ADAMS RITE 4501/4901
SERIES LIP STRIKE
TEMPLATE
WHEN USING POWER TOOLS
ALWAYS WEAR
EYE AND EAR PROTECTION!!
Copyright 2007—Major Manufacturing
Advertisement
Related Manuals for Major Manufacturing ADAMS RITE 4501 Series
Summary of Contents for Major Manufacturing ADAMS RITE 4501 Series
- Page 1 1825 VIA BURTON ANAHEIM CA 92806 714-772-5202 / FAX 714-772-2302 EMAIL: MAIL@MAJORMFG.COM WEB: WWW.MAJORMFG.COM INSTRUCTIONS FOR HIT-40AR4 ADAMS RITE 4501/4901 SERIES LIP STRIKE TEMPLATE WHEN USING POWER TOOLS ALWAYS WEAR EYE AND EAR PROTECTION!! Copyright 2007—Major Manufacturing...
-
Page 2: General Safety Rules
MAKE CERTAIN THAT YOU ARE USING THE CORRECT TEMPLATE FOR THE STRIKE BEING INSTALLED AND YOUR ROUTER HAS A 3/8” OUTSIDE TEMPLATE GUIDE INSTALLED IN THE BASE. GENERAL SAFETY RULES ALWAYS WEAR EYE AND EAR PROTECTION!! Before attempting any installation know how to safely use the power tools involved and how they work. - Page 3 See our catalog or web site for a list of available router template guides. Install a 1/4” diameter aluminum router bit into the router collet and secure tightly. Adjust the router bit so it will route about 1/4” to 3/8” into the door channel. Copyright 2007—Major Manufacturing Page 3...
- Page 4 The strike plate has two openings. Only one will be used depending on the hand of the door, the other will be filled by the black plastic dust cover. Copyright 2007—Major Manufacturing Page 4...
- Page 5 The center line is 7/8” from the stop, or one half the thickness of the door. Use a combination square and draw a vertical line at this point. Copyright 2007—Major Manufacturing Page 5...
- Page 6 Tapmatic Edge Cream made by the LPS Company. You can find this product at industrial hardware stores or machine shop supplies. This is also a handy product to use for other drilling or tapping chores. Copyright 2007—Major Manufacturing Page 6...
- Page 7 Failure to do so may cause damage to the door, your HIT-40 template, or injury to your- Copyright 2007—Major Manufacturing self. Page 7...
- Page 8 Remove the router template , clean off the lube and de-burr the sharp edges with a scraper or a file. Drill out the holes left by the tek screws to 3/16”. These holes will be used to mount the factory mounting bracket. Copyright 2007—Major Manufacturing Page 8...
- Page 9 Counter sink the top and bottom holes for 10-32 flat head screws. Mounting bracket inside opening and first screw being installed. Factory bracket installed. Copyright 2007—Major Manufacturing Page 9...
- Page 10 Black plastic dust box installed in mounting bracket. Install strike plate using factory supplied 10-32 flat head screws. Completed installation. That’s all there is to it! Copyright 2007—Major Manufacturing Page 10...