Table of Contents
Advertisement
Possible Causes
- Improper loading
- Load the dishwasher as suggested in the directions.
- Increase the amount of rinse aid / refill the rinse aid dispenser.
- Too little rinse aid
- Do not empty your dishwasher immediately after washing.
- Dishes are removed too soon
- In short programmes the washing temperature is lower. This
- Wrong programme selection
- Water drainage is more difficult with these items. Cutlery or
- Using cutlery with a low-quality
coating
Possible Causes
- Wrong programme selection
- Select a programme which washes at a higher temperature
- Detergent is moist or clumping
- Bleaches in cleaners lose their efficacy when stored under
- Using cutlery with a low-quality
coating
- Cleaning of these items is made difficult by their surface
Possible Causes
- Too little rinse aid
- Increase the amount of rinse aid / refill the rinse aid dispenser.
29
All manuals and user guides at all-guides.com
The dishes are not drying
Solutions
Open the door slightly so that the steam can escape. Begin
unloading the dishwasher only once the dishes are barely
warm to the touch. Empty the lower basket first. This prevents
water from dripping off dishes in the upper basket.
also lowers cleaning performance. Choose a programme
with a longer washing time.
dishes of this type are not suitable for washing in the
dishwasher.
Tea, coffee, or other stains
Solutions
or takes longer.
unfavourable conditions. Store detergents in a dry location.
Close the lid of the container carefully
structure. Cutlery or dishes of this type are not suitable for
washing in the dishwasher.
Calcium streaks or a
cloudy appearance
Solutions
- The correct water hardness has
- Check the values set against the values given by your local
not been selected; too little salt is
water board.
being used.
- Salt loss
- Check that the lid of the salt dispenser is firmly closed. Use
the funnel to pour in special salt. Begin the pre-wash
programme immediately after filling up the salt. Once the
programme is complete, check whether the lid has come
loose.
Odour
Possible Causes
Solutions
- Smell of new appliance
- The smell of a new appliance disappears after a few wash
cycles.
- Strainers are dirty
- Clean all strainers and filters as described in the manual
- Remove heavy soiling under running water and run the
- Dishes standing in the appliance for
pre-wash programme without any detergent every 2 days.
several days without being washed
Close the door to prevent odours from developing.
Milky appearance or shiny blue
deposits on glassware
(glass corrosion)
Possible Causes
Solutions
- Excessive use of detergent when
- Choose a programme with a low temperature and add a
water hardness is low, cleaning
smaller amount of detergent. Check the values set against
temperature is too high
the values provided by your local water board
Rust stains, surface
damage
Solutions
Possible Causes
- Salt can destroy metal surfaces and cause rust damage.
- The lid of the salt dispenser is not
- Check that the lid of the salt dispenser is firmly closed. Use
closing properly.
the funnel to pour in special salt. Begin the pre-wash
programme immediately after filling up the salt. Once the
programme has finished, check whether the lid has come
loose.
3
Advertisement
Table of Contents
