Factory Reset; Step 1: Uninstall Fortisiem Application; Step 2: Reinstall Fortisiem Application - Fortinet FortiSIEM 3500F Hardware Configuration Manual

Factory Reset

Factory Reset
Follow the steps below to perform factory reset on FortiSIEM FSM-3500F.

Step 1: Uninstall FortiSIEM application

1. Connect FortiSIEM device using VGA or Console port.
2. Login as ' root ' user with password 'ProspectHills'.
3. To check the available FortiSIEM commands, run get .
4. To uninstall FortiSIEM, run execute fsm-clean .
This script will uninstall FortiSIEM application.

Step 2: Reinstall FortiSIEM application

1. Power on the hardware.
2. Login as ' root ' without password 'ProspectHills'.
3. To configure RAID, run execute format disk .
4. To check Hardware status and RAID information, run diagnose hardware info .
5. To install FortiSIEM, run execute factoryreset .
This script takes 5 minutes to complete FortiSIEM installation.
6. To configure network on FortiSIEM, stop FortiSIEM services by running sudo execute preparebox .
This script will stop running FortiSIEM services and power offs the hardware.
Follow the steps under
FortiSIEM 5.4.0 3500F Hardware Configuration Guide
Fortinet Technologies Inc.
Appliance Setup to configure FSM-3500F.
8