Advertisement
PARTS
FRONT
Diagram Part
Number
1
2
3
4
5
6
7
8
9
10
11
The incubator may be cleaned of feather dust and hatching debris with a damp cloth and mild soap, for those surfaces accessible from the front door. Finish with a wipe
CLEANING &
or spray of a mild disinfectant. Plastic egg racks are machine washable. The hatching tray should be washed and disinfected after each hatch. At the start or end of a
SERVICE
season it is recommended that the top and back of the incubator be removed so that feather dust may be removed. To do this, turn off and unplug the incubator before
removal of the top and back. Use a soft bristle paint brush to remove feather dust. Take care not to stretch the heat element if cleaning in that area. Do not wet down
or spray into electrical boxes, heater or motors. Other surface areas may be wiped with a damp cloth and a mild disinfectant used in the same manner.
WARRANTY &
GQF Manufacturing Co., Inc. guarantees against defect for a period of 1 year from date of purchase. This warranty is void for product more than 3 years old when not sold direct
from GQF to the consumer. Notify GQF Mfg. Co. of any defective items, giving catalogue number and name of item and what is wrong with item. Send copy of invoice showing
RESTRICTIONS
date of purchase. GQF Mfg. Co. will send replacement, or replacement parts, or notify regarding return. Shipping charges for express shipping are to be paid by the customer.
GQF's warranty applies to residents of the USA only. International warranty claims are handled by the authorized GQF dealer that sold the equipment in that area. Returning of
items without written permission will be at owner's expense.
Whereas GQF Mfg. Co. has no control over usage of equipment and product supplied, it assumes no responsibility for losses or damage from the equipment or product other than replacement of defective parts. No
guarantee on hatchability of eggs. GQF assumes no responsibility for losses due to shipping damage, late shipment or arrival of product.
Do not expose electrical parts to water. Installation of electrical parts should be done by a qualifi ed electrician. Use of replacement parts other than intended by GQF Mfg. Co. is not permitted. Custom modifi cations
and use of non GQF parts can void the warranty. GQF is not responsible if product does not comply with local product codes or codes outside of the USA.
1.4.1 Normal environmental conditions - This equipment designed to be safe at least under the following conditions: a) indoor use; b) altitude up to 2000m; c) temperature 5
humidity 80% for temperatures up to 31
present on the mains supply (impulse withstand category II 1500 V transient; g) pollution degree 2.
Unit must be plugged into a grounded outlet to maintain the safety of the equipment. This appliance must be located so the power switch and cord set are accessible as they are relied upon to
disconnect the device. Appliance protection may be impaired if used in a manner not speci ed by the manufacturer.
GQF Part
Item
Number
Description
No 4502
Humidity wick pads (2)
No 4500
Humidity pan
No 3170
Heater assembly 110V
No 3043
Front support bar
No 3045
Door gasket
No 3051
Complete door latch (1)
No 3063
Set of 4 hinges for door
No 3070
Back panel
No 3073
No 3077
Top panel
No 3036
Hatching tray
IF THE EQUIPMENT IS USED IN A MANNER NOT SPECIFIED BY
THE MANUFACTURER, THE PROTECTION PROVIDED BY THE
o
C decreasing linearly to 50% relative humidity at 40
G.Q.F. MANUFACTURING COMPANY
Phone 912-236-0651 P.O. Box 1552 - Savannah, GA 31402 www.GQFMFG.com
DIAGRAM PART
NUMBER
1
12
2
13
3
14
4
15
5
16
6
17
7
18
8
19
9
20
10
21
11
22
Diagram
Number
12
13
14
15
16
17
18
19
20
Door
21
22
EQUIPMENT MAY BE IMPAIRED.
C; e) mains supply voltage fl uctuations up to + 10% of the nominal voltage; f) transient overvoltages typically
o
— All 110V units 110V, 50/60Hz, 325W
— All 220V units 220V, 50/60Hz, 350W
BACK
GQF Part
Item
Number
Description
No 3179
Off/On switch with fuse
No 3178
Fuse 250-V 5amp fast blow
No 3248
Analog Electronic Thermostat
No 3170
Heater/Fan Assembly
Turner assembly 110V (after
No 3175
2007 production)
No 3048
IEC/USA cord set for cabinet
No 3182
Black vent plugs
Turner timer motor (attached
No 3023
to thermostat panel)
No 3041
Rear connecting bar
No 3047
Back and top gasket
No 3078
Foot Pad Assembly
o
C to 40
o
C; d) maximum relative
Advertisement
