ubbink RobotClean Accu User Manual page 4

1 Robotclean Accu Operating Instructions and Parts List
Öffnen und Schließen des Gehäuses
Opening and closing the housing
Opening
Montage der Bürste
Drücken Sie die Bürste in die an der
Fitting the Brush
1 Außenseite des Gehäuseunterteiles
vorgesehenen Einkerbung
1. Push the brush into the notch provided on the outside of the lower part of the housing.
Montage der Bürste
2. Make sure that the brush sits tightly.
2 Stellen Sie sicher, dass die Bürste fest sitzt.
Drücken Sie die Bürste in die an der
1 Außenseite des Gehäuseunterteiles
vorgesehenen Einkerbung
Removing the brush
Demontage der Bürste
2 Stellen Sie sicher, dass die Bürste fest sitzt.
1. Push the brush out of the notch on the inside of the lower part of the housing.
1 Drücken Sie die Bürste von der Innenseite
2. Remove the brush.
Demontage der Bürste
des Gehäuseunterteiles aus der Einkerbung
1 Drücken Sie die Bürste von der Innenseite
des Gehäuseunterteiles aus der Einkerbung
Tip: The use of the brush is not recommended when it does not assist the cleaning of the pool, for example if there is a slope or there is too much dirt at the bottom of the pool.
Start-up
1. Before charging - turn the on/off button to OFF.
2. Clean the charging connection before charging up.
3. Push the charging cable into the charging connection of the pool cleaner to charge the battery.
- The red charging control light indicates that the battery is being charged.
- The green charging control light indicates when the charging process is completed.
4. When you have made all the settings you can let the cleaner sink carefully and slowly into the pool. Make sure that all air has escaped from the housing before it has sunk to the
bottom.
5.Turn the switch button to ON. The pool cleaner activates automatically as soon as it is fully immersed in water.
The floor vacuum cleaner starts to work about 15 seconds later whilst the blue light is flashing.
The pool cleaner changes direction automatically as soon as it touches the pool wall (or in the case of curved floors starts to climb upwards and backwards), and the blue light is
flashing.
After that the indicator light of the pool cleaner flashes green for a few seconds as it adjusts its direction independently. After that the indicator turns blue again.
The yellow light flashes three times when the working cycle is completed. The pool cleaner goes into standby mode and the control light is constantly yellow.
Switching-off procedure:
Turn the switch button in the direction of the red light until the pool cleaner has switched off.
Öffnen und Schließen des Gehäuses
Öffnen
Montage der Bürste
1
Closing
Drücken Sie die Bürste in die an der
Außenseite des Gehäuseunterteiles
vorgesehenen Einkerbung
IMPORTANT: The pool cleaner must always be inserted into the pool or taken out in such a way that the
underside of the pool cleaner is directed towards the pool wall to avoid any possible scratches to the pool or
membrane surface.
Schließen
Öffnen