Troubleshooting - Audiovox RCRN03BR Owner's Manual

5. Repeat step 4 until you have retrieved all five
numbers in the code. After the fifth number is re-
trieved, the POWER key blinks briefly, then turns off.
TIP: To exit the Code Retrieval Mode at any time,
press the EXIT key.
Note: If you press an invalid key during the Code
Retrieval process, the remote will not respond. If you
do not press a valid Code Retrieval key (TV, SAT•C-
BL•DTC, DVD•VCR, INFO, EXIT), Code Retrieval
times out after 15 seconds. The POWER key blinks
four times, and then turns off.

Troubleshooting

Problem: The remote does not operate your device.
• Make sure the remote is in the correct mode by
pressing the corresponding device key (TV, SAT•C-
BL•DTC, DVD•VCR). This tells the remote which
device to operate.
• Remove any obstacles between the remote and
the device. Make sure you're aiming the remote at
the device's IR sensor.
• Make sure the batteries are fresh and are proper-
ly installed. Replace the batteries with two new AAA
batteries, if necessary (see the Battery Installation
section).
Problem: The remote can't be programmed to oper-
ate your device.
• If you are testing the remote while programming
it, you may be too far away from the device or at
a wrong angle. There must be an unobstructed
path between the remote and the IR sensor on the
device. Move closer and make sure you point the
remote at the device you're trying to control.
• If you're using the Direct Entry programming
method to enter the codes for your brand and the
unit is still not functioning properly, try the auto,
brand, or manual search method.
• To control combo units, like TV/VCRs or TV/DVDs,
you must program the individual corresponding
device keys to control each part of the combo unit.
Once programmed successfully, the TV key controls
the TV functions, and the DVD•VCR key controls the
VCR or DVD functions.
• Make sure the batteries are fresh and are proper-
ly installed.
Problem: The remote doesn't perform commands
properly.
• Make sure the remote is in the correct mode by
pressing the corresponding device key (TV, SAT•C-
BL•DTC, DVD•VCR). This tells the remote which
device to operate.
• Make sure device is ready (for example, the DVD
player has a disc loaded).
• You may have pressed an invalid key for the mode
the remote is in.
• If you're trying to enter a channel number direct-
ly, try pressing the ENTER key after entering the
channel number as this is a requirement of certain
models and brands.
• There is a possibility that a programmed code
may only be able to control some of your device fea-
tures (for example, only turns a device on and off).
To confirm that the device key is programmed with
the correct code for maximum functionality, test the
device. Attempt to control a variety of the device's
functions with the remote. If some of the features
of your devices don't work, try programming the
remote with a different code in the list using the
Direct Code Entry Method, until you find the code
that allows the remote to control the majority of
your device's functions. Different codes can provide
different levels of functionality.
Problem: The POWER key does not light when you
press a key.
• You may have pressed an invalid key for the mode
the remote is in.
• Make sure the remote is in the correct mode by
pressing the corresponding device key (TV, SAT•C-
BL•DTC, DVD•VCR). This tells the remote which
device to operate.
• Make sure the batteries are fresh and are proper-
ly installed. Replace the batteries with two new AAA
batteries, if necessary (see the Battery Installation
section).