Tour Of The Remote - Audiovox RCRN03BR Owner's Manual

1. Manually turn on the device you want to control.
2. Press and hold the device key you want to pro-
gram. The POWER key illuminates.
While you're holding down the device key, use your
other hand to press and hold the remote's POWER
key at the same time. The POWER key turns off.
3. Wait until the remote's POWER key comes on and
stays on, Then release both keys.
4. Point the remote directly at the front panel of the
device you want to control. Press POWER on the
remote and wait 2 seconds. The remote is testing a
single code for your device.
Did your device turn off?
Yes: Press the STOP key to store the code. You're
done! You've programmed this device key.
No: Press POWER again. The remote tests the next
code for your brand. Keep pressing POWER every 2
seconds until your device turns off.
Tip: Because there are so many codes, yu may have
to press the POWER key many times--possibly hun-
dreds of times.
Notes: Throughout the programming of each key,
keep the remote pointed at the IR sensor of the de-
vice you are programming the remote to control.
Test the remote with the device to make sure the
device key is programmed with the correct code
for maximum functionality. If some features don't
work, try a different code. See the "Testing the Code
for Maximum Functionality" section below for more
information.
During the Manual Code Search, the remote ignores
keypresses that aren't part of the search.
The search times out after two minutes (the POWER
key blinks four times and turns off, and the last pro-
grammed code under that device key is retained).
The POWER key blinks four times and turns off
when the remote has gone through all the codes.
The remote exits the Brand Code Search. If your
device hasn't turned off yet, try a different search
method.

Tour of the Remote

In most cases, the keys on this remote perform the
same functions as the keys on your original remotes
once you've programmed this remote to operate
your components. Many keys on this remote have
other functions as well.
Illuminated POWER key serves as an indicator light
to provide feedback.
Device keys (TV, SAT•CBL•DTC, DVD•VCR) put the
remote in the right mode to control your device.
GUIDE and MENU put the remote in menu/guide
mode; they also access the same features as thek-
eys on your original remotes.
EXIT exits remote programming; it also performs the
same functions as on your original remotes.
Arrow keys act as navigation keys in device guides
and menu systems.
The INPUT•DIGITAL and — (dash) key has three
functions: (1) it toggles through all video sources
connected to your TV; (2) when the remote is in VCR
mode, this button toggles between VCR and the TV
input; (3) when you enter digital channel numbers
directly, it lets you separate the main channel num-
ber from the sub-channel number (e.g., 59.1).
Backlight key turns backlighting on/off.
IMPORTANT
Because this remote con-
trols more than one de-
vice, you must first "tell"
the remote which device
you wish to operate. That
means, if you wish to oper-
ate TV, you must first press
the TV key to put the remote
in the TV Mode. The remote
stays in that device mode
until you press a different
device key. For example, if
your remote is in TV Mode
and you want to operate the
DVD player, you must press
the DVD•VCR key to change
device modes.