Advertisement
INSTALLATION LOCATION
WARNING
The wall where the mount is to be installed must be capable of long-term support of the
total load of the monitor and mount. Measures should be taken to ensure sufficient
strength to withstand the force of earthquakes , vibrations and other external forces.
Note:
Incorrect installation can cause the monitor mount to fall and cause injury.
Total load of the mount ( monitor + Mount)
Maximum weight - 20 Lbs ( 10Kg.)
CAUTION
Avoid installing in locations where the temperature and humidity are excessively high, and where contact with any
water is possible. These can result in fire or electric shock.
.
Do not install in locations where there is excessive vibration or impact. Injury and damage could result from the monitor mount
.
falling.
.
WARNING
Use the specified screws in the specified places and tighten firmly. Failure to do this could cause injury if the monitor.
mount falls.
.
Do not alter any of the parts. Do not use broken parts. This
.
C A U T I O N : I N S T A L L A T I O N O F U N I T I S T O B E C A R R I E D O U T B Y Q U A L I F I E D T E C H N I C I A N S O N L Y . I N S T A L L I N
A N A P P R O P R I A T E L O C A T I O N B Y C H E C K I N G T H E S T R U C T U R E A N D D U R A B I L I T Y F O R S A F E T Y A N D
A C C I D E N T P R E V E N T I O N .
.
.
.
.
could result with injury due to the monitor mount falling. .
.
2
1 FASTENING THE MOUNTING PLATE TO THE WALL
Locate the best viewing angle for the monitor, and using the 4 wall anchors supplied, attach the mounting plate
to the wall. Place the narrow end of the plate facing downward. Alternate hardware may be required if attaching
to a solid surface.. See fig 3 and fig 4
Mounting plate
Wall anchors
Mounting surface
½"wall board
2 ATTACH THE MOUNT TO THE MONITOR
Lay the monitor on a soft surface ,face down, and attach the mount using 75mm or 100mm VESA hole
pattern and the 4 screws supplied. See fig 5 ( note top of monitor)
NOTE: Do not over tighten the bracket mounting screws as damage to the monitors internal mounting threads could occur.
Fig 5
Top of Monitor
Fig 4
Mounting plate
M o u n t i n g s c r e w s
75mm & 100mm
Vesa hole pattern
3
Advertisement
