Advertisement
Refer to fig.1
4.1.
Lay the base tray, edges upwards, on a flat surface.
4.2.
Using the nuts and dome-headed screws supplied, attach the columns as shown. The rectangular slots at the top of the columns
should face sideways.
4.3.
Attach the middle tray as shown.
4.4.
Lower the drawer unit into the columns and attach.
4.5.
Slide the handle brackets through the rectangular slots and secure from the front (the handle brackets are provided with threaded holes to
secure on the inside).
4.6.
Secure the screwdriver holder to the opposite end of the drawer assembly as in fig.2.
4.7.
Lay the trolley on its side and fix the castors to the base tray at the same end as the handle. Use four nuts and hex headed screws each.
4.8.
Fix the two fixed wheels to the opposite end in the same manner.
4.9.
Check that all fixings are tight.
5. MAINTENANCE
5.1.
Oil the castors periodically with light oil.
5.2.
Clean with a damp cloth. DO NOT use abrasive or solvent cleaners.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
01284 703534
sales@sealey.co.uk
Original Language Version
fig.2
www.sealey.co.uk
AP760MSERIES Issue: 1 - 04/01/18
Advertisement
