Haier N Series Service Manual page 49

10.4.11 Loss of synchronism detection
Inverter side current detection is abnormal
Outdoor Display LED1 flash 18 times
LED1 flash 19 times
Method of The position of the compressor rotor can not detected normally
Malfunction
Detection
Malfunction when the wiring of compressor is wrong or the connection is poor;
Decision or the compressor is damaged
Conditions
Supposed
Causes
Troubleshooting * Caution Be sure to turn off power switch before connect or disconnect connector, or parts
Within 3 minutes after the machine is
supplied with power and turned on with
the remote controller, check whether
the compressor can start up
At first, the compressor start up ,soon the
compressor stopped with the LED1 on the
outdoor PCB blinks 1Hz 19/18 times
Maybe there is some disturbance
Faulty The wiring of compressor
Faulty compressor
Faulty PCB
damage may be occurred.
YES
NO
1. The wiring of compressor is incorrect
2. The compressor is damaged
YES
IPM Module is damaged and needs
Malfunction unsolved
the
47
Service diagnosis
or the connection is poor;
replacing.
Malfunctions exist also,
compressor is damaged replace a
new one
Domestic air conditioner
the