LENCO PDR-040 User Manual page 12

CAUTION!
Risk of injury!
Opening the device can cause injuries.
Fault Possible cause/action
No function - If the device has been disrupted by a thunderstorm,
a static charge or another external factor, follow this
procedure to resolve the problem: Power off this
device and power on it again 10 seconds later.
- Disconnect the supplied adapter and then plug it in
again.
No sound - The volume may be set too low or in mute mode.
- In Bluetooth mode: Set the volume of the external
device to the maximum and then control the volume
by using "Rotary button (07)".
No/bad radio - If necessary, select another location to improve the
reception radio signal.
- Adjust the telescopic antenna to optimize the radio
reception.
No Bluetooth® - Take care to ensure that all settings have been made
connection correctly on all devices. The Bluetooth® function
may be deactivated on the external device. (re)
activate it, if necessary.
- Check whether the device to be connected is
switched on and is in search mode.
12. Specification
Device: Portable Bluetooth DAB Radio
Unit Dimension 155 (L) *90. 5mm (W) *32mm (H)
Unit Weight 285g
Display Type
Size
Bluetooth Specification
Supported Profile
Connection Distance
Power
DAB Tuning Range
Preset Memory
FM Tuning Range
Stereo/Mono
Preset Memory
Audio Output Power
Power Source Input
Built-in-Battery
Operating Temperature
Power supply adaptor (For EU only)
Manufacturer: Shenzhen Tianyin Electronics Co. , Ltd.
Model number: TPA-67B050100VU01
Input voltage : 100-240V
Input AC frequency : 50/60Hz
Output voltage : 5V
Output current : 1.0A
Output Power : 5W
Average active efficiency : ≥73.63%
No load Power consumption : 0.1W
Use only the power supply listed in the user instructions
Guarantee
Lenco offers service and warranty in accordance to European law, which
means that in case of repairs (both during and after the warranty period) you
should contact your local dealer.
Important note: It is not possible to send products that need repairs to Lenco
directly.
Important note: If this unit is opened or accessed by a non-official service
center in any way, the warranty expires.
This device is not suitable for professional use. In case of professional use, all
warranty obligations of the manufacturer will be voided.
LED Display
Disclaimer
48mm x 13mm
Updates to Firmware and/or hardware components are made regularly.
V5.0
Therefore some of the instruction, specifications and pictures in this
A2DP, AVRCP, HSP
documentation may differ slightly from your particular situation. All items
In 10 meters (open
described in this guide for illustration purposes only and may not apply to
area)
particular situation. No legal right or entitlements may be obtained from the
Class II
description made in this manual.
Band III; 174.928MHz
– 239.2MHz
Disposal of the Old Device
30 stations
87.5 - 108MHz
Selectable
30 stations
12
Antenna
Output Power
Freq. Responses
Micro USB Port
PC's USB port Power or DC 5V, 1A
Lithium 3.7V 2000mAh
0-40°C
This symbol indicates that the relevant electrical product or
battery should not be disposed of as general household waste
in Europe. To ensure the correct waste treatment of the
product and battery, please dispose them in accordance to
telescopic type
1X3W RMS
80Hz to 16, 000Hz