Page 1
1. Plug the 1-sided end of the DHSG cable marked in blue into the socket marked with the "headset" symbol on your OpenStage phone. 2. Insert the RJ9 plug into the socket with the "phone" symbol and the RJ45 plug into the socket marked with "AUX" on the Jabra GN912x base. EHS setup: https://www.jabra.sg/supportpages/jabra-gn9120/9120-281-11/faq/fedb71fc-421c-46ae-...
Page 2
28/06/2021 15:40 The Jabra GN912x must support and be set up on DHSG EHS. You can check or set it as follows: 1. Put the headset in the base. 2. Then press the PLUS and MINUS buttons simultaneously for 6 seconds until the online display on the headset starts to flash.
Page 3
2. You can now increase the microphone volume with PLUS and decrease it with MINUS. 3. To confirm, after approx. 10 seconds a low signal tone sounds. All the settings are then automatically saved. Phone setup: https://www.jabra.sg/supportpages/jabra-gn9120/9120-281-11/faq/fedb71fc-421c-46ae- Page 3 of 4 8b8c-1f91986e5f24...
Page 4
OpenStage 60/80: Menu> User> Audio> Settings> Headset> Cordless Important: The dial tone signal in the headset will only transfer when the standard ring tones are used on your phone. There is no dial tone signal transfer for MP3 ring tones. https://www.jabra.sg/supportpages/jabra-gn9120/9120-281-11/faq/fedb71fc-421c-46ae- Page 4 of 4 8b8c-1f91986e5f24...