Subscribe to Our Youtube Channel
Related Manuals for MFZ Ovitor TVR(FC) 5
Summary of Contents for MFZ Ovitor TVR(FC) 5
- Page 1 OPERATING AND MAINTENANCE INSTRUCTIONS DOOR OPERATOR TVR(FC) 5 OVITOR OY SIENITIE 24 FIN‐00760 HELSINKI FINLAND Tel. +358 (0) 207 106 600 Fax. +358 (0) 207 106 601...
-
Page 2: Table Of Contents
The safety instruc ons must be observed Warning! Danger to property! The safety instruc ons must be observed! Informa on Special informa on Reference to other sources of Fig. 1. informa on Serial number: 2 ‐Door operator TVR(FC) 5 / Rev 1.41... -
Page 3: Safety Instruc Ons
The plate on the gear box shows (fig. 1), in addi on to the technical informa on, also the produc on serial number (e.g. MLN9878/1), on the basis of which all original produc‐ on informa on can be traced later. Door operator TVR(FC) 5 / Rev 1.41 ‐ 3... -
Page 4: Product Range
An exploded view of the drive unit and the part num‐ bers can be found later in this manual. 4 ‐Door operator TVR(FC) 5 / Rev 1.41... -
Page 5: Electrical Installa On
A er ghtening the bolts, check that the lever of the disengagement clutch func ons properly. The lever must turn 90 degrees. Control current Fig. 4. Door operator TVR(FC) 5 / Rev 1.41 ‐ 5... -
Page 6: Set Up
Slipping clutch lining Worm sha Lock nut (M8) Adjustment screw for torque of slipping clutch Fig. 6. Adjustment of the limit switches Fig. 5. Slipping clutch 6 ‐Door operator TVR(FC) 5 / Rev 1.41... -
Page 7: Digital Se Ng -Ave Limits
Please refer to the control unit’s oper‐ a ng manual for instruc ons on se ng the end posi ons. Thermal element in the drive Manual emergency control (crank or chain) Disengagement Door operator TVR(FC) 5 / Rev 1.41 ‐ 7... -
Page 8: Opera On
Fig. 7. Disengagement clutch When changing the oil, please note that hot oil may cause burns. Always use protec ve gloves and remove leaking oil immediately with an oil‐absorbing substance. 8 ‐Door operator TVR(FC) 5 / Rev 1.41... -
Page 9: Changing The Fric On Lining Of The Slipping Clutch
The permi ed service life of the door operator is 12 000 opera ng hours with the maximum permi ed nominal out‐ put of the electric motor. Door operator TVR(FC) 5 / Rev 1.41 ‐ 9... - Page 10 The motor runs, but gear sha is not turn‐ Slipping clutch is slipping Adjust or replace the slipping clutch Clack between the gear and motor Flexible clutch worn out Replace the clutch 10 ‐Door operator TVR(FC) 5 / Rev 1.41...
- Page 11 Door operator TVR(FC) 5 / Rev 1.41 ‐ 11...
-
Page 12: Declara On Of Incorpora On Of Partly Completed Machinery
Descrip on and iden fica on of the partly completed machinery: Door operator TVR(FC) 5 with various limit and gear transmissions The essen al requirements of EC Machinery Direc ve 2006/42/EC have been applied and fulfilled for the above men oned machinery to be used with industrial doors, gates and barriers.
Need help?
Do you have a question about the TVR(FC) 5 and is the answer not in the manual?
Questions and answers