Page 1
Side Cutter, Engineer´s File Locking Clamp Slot Screwdriver Phillips Screwdri- Please Note The OPITEC range of projects is not intended as play toys for young child- Sandpaper Round File Ruler Pencil ren.They are teaching aids for young people learning the skills of Craft, Design and Technology.These projects should only be undertaken and te-...
Page 2
Instructions 101.141 LT-Racer with Propeller Drive Contents List: Qty: Size (mm): Designation: Part No.: Motor R140 Drive Spring-Steel Clamp 17-22 Motor Mount Rocker Switch 16,3 Switch Chipboard Screw 16x3 Mount Spring-Steel Clamp Cylinder Head Screw 25x4 Screw Connection Front Screw Connection Front...
Page 3
Instructions 101.141 LT-Racer with Propeller Drive Transfer the template for the intermediate piece (5) (page 9)on the Cut the wooden strip (4) according to the instructions and clen the plywood (5) and saw it with the fretsaw. Clean the saw cuts with the saw cuts.
Page 4
Instructions 101.141 LT-Racer with Propeller Drive Fix the propeller blades (20) with the cylinder head screws (21) on the Put the spring steel clamp (12) centrical on the motor mount (2) as propeller hub (22) as shown. Afterwards put the rotor on the motor shown and fix it with the chipboard screw (14).
Page 5
Instructions 101.141 LT-Racer with Propeller Drive ø4 Now drill the intermediate piece and the base with a 4mm drill use Glue the top on the intermediate piece (5) and the wooden strips (4a - the drill in the upper part.
Page 6
Instructions 101.141 LT-Racer with Propeller Drive Insert the metal axis (9) as shown and clip on spacers (7) on each side. Insert battery and get on the road! Then fix the impellers (6).
Page 7
Instructions 101.141 LT-Racer with Propeller Drive Front Position Motor Bracket Battery Compartment Connecting Piece Rear Axle Position...