ATN NVG7-HPT User Manual page 5

If you need increase the eye relief of your goggles, you
can displace the bracket on the top of NVG-7.
1) Unscrew the screw and detach the end-cap from
the bracket of NVG-7.
2) Unscrew the 2 screws and detach the bracket from
the NVG-7 body.
3) Turn the bracket 180 degrees.
4) Screw the 2 screws back into place.
hlm mon
Helmet mount for attachment of ATN's NVG-7 to a standard PASGT helmet. Helmet mount fits
securely onto helmet via a rugged strapping device and grooved hooks. With helmet mount,
NVG-7 can be positioned directly in front of user's eyes or flipped.
InsTAllATIon
1) Install the mount onto helmet as shown on the picture.
2) Tighten and fixate the straps [1]
3) Attach goggles to the rail. Push button [2] and insert
the bracket of the NVG-7 to the rail of the mount.
4) Place the helmet on your head.
ADJusTmEnT
1) Loosen the screw [3] and move the unit along the rail
for eye relief adjustment. Tighten the screw [3].
2) Loosen the top vertical fixation screw [4]. Adjust gog-
gle vertical position. Tighten vertical position screw.
3) The NVG-7 helmet mount has a flip-up mechanism. Push a button [5] on the side of mount
and lift the unit up till fixation in the top position.
The helmet mount has an adjustment of
angular position of device relatively of
the look axis.
1) Loosen two screws on the front of
flip-up mechanism.
2) Rotate device around axis of mecha-
nism to the necessary position.
3) Tighten the two screws again.
inchngbl ln
The NVG-7 with 3X or 5X front lens can be
used as a powerful night vision bi-ocular.
To install 3X Afocal Lens screw it into the
front lens of NVG-7.
To install 5X lens unscrew the objec-
tive lens of NVG-7 and screw 5X lens to
the free place (make sure that the unit is
turned off).
(o p  i o n  l )
4
2
3
±10˚
(o p  i o n  l )
5X Lens
1
1
5
3X Lens
4