Advertisement
• High Quality 2
• Super fast lens system provides the user with a clear and sharp image
• Dual eye viewing system for long viewing sessions
• Built-in Infra Red illuminator lets you see even in total darkness
• Interchangeble lenses for different magnification
• Head or helmet mounted for hands free use
• Rugged and versatile design
• Easy to use digital controls
• Two-Year Warranty
pplicion
Compact and lightweight, rugged, and a top-notch performer the NVG-7 is an exceptional
choice for hands free usage.
The NVG-7 goggles have a built in IR for total darkness with indicator "ON" light within the FOV
and a flip-up headset.
The NVG-7 is available with a wide range of image intensifier options to meet a wide array of
specification requirements.
The NVG-7 night vision goggles is a complex opticoelectronic system for individual use. The
device consists of the objective lens assembly, eyepiece and the body. The body contains a
image intensifier tube assembly with an integrated high voltage power source and the battery
housing.
Objective lens protective cover (not shown) is intended to protect the objective lens from dust
and scratches. It also will act as a daylight filter, allowing you to test the scope in daylight or
other bright light situations. The pinhole in the center of the protective cover allows the user to
check the operation ability of the device in daylight conditions.
NOTE: Do not test the scope in daylight conditions even with the daylight filter/lens cap on for
more than ten (10) minutes.
opion
• Take the monocular out of the case.
• Install the battery into the housing with the polarity order as shown on the scope. Battery
Type: 3 Volt, Lithium, CR123A .
• Press the button (short press - less than 1.5 sec.) to turn the unit on by the protective lens
cover still attached to the lens. Do not turn the unit on in the daytime without the protec-
tive lens cap on. You should see green glow in the eyepiece.
• Observe the scene and adjust the diopter for optimal image clarity.
• You may now enter a dark environment or simply shut the lights off in order to darken the room.
• Next, remove the lens cap/daylight filter. Adjust the front lens for the distance of the focus.
You should not have to readjust the diopter.
• To turn the unit off, push the button again by short press (less than 1.5 sec.).
or 3
gen. light intensifier tube
nd
rd
2
Advertisement
