Source language: German Explication of warning symbols Safety instructions /// Warning symbols /// General information Danger! Indicates an (extremely) hazardous situation, which, if not avoided, will › Read the operating instructions completely before starting up and follow the safety result in death, serious injury� instructions.
› Please unpack the vessel carefully� › Any damage should be notified immediately to the shipping agent (post office, railway net- work or logistics company)� Vessel Vessel Name: IKA MultiDrive BL 2000 T 20:00 Maintenance Time: hh:mm Reset Maintenance Time:...
/// Filling the vessel The temperature measurement with the vessel MultiDrive BL 2000 T works exclusively with the MultiDrive control� When the “Temperature Limit“ is set in MultiDrive control that the device stops after the temperature is reached� With the setting, both sample and the vessel can be protected from overheating�...
Page 7
/// Using the filling opening /// Switching on the drive unit › Opening the filling opening: › Filling medium via the filling opening: green Caution! Caution! Add medium only when the drive unit is in Don’t open the filling opening when the drive Note: After the cover has been securely closed, the color of the LED signal lamp changes from standby status! unit is running!
/// Opening the vessel after processing Maintenance and cleaning The vessel is maintenance-free� It is only subject to the natural wear and tear of components and their statistical failure rate� /// Cleaning › Use only cleaning agents which have been approved by IKA to clean the devices: water (contain- ing surfactant) and isopropyl alcohol�...
Page 9
Clearance ≈ 1.5 mm Click Notice! Caution! When assembling, ensure the vessel base is assembled to properly position! The edges of the blending tool are sharp� Wear protective gloves for handling and please observe the safety instructions� To loosen the retaining nut of the blending tool, turn the socket wrench in clockwise direction (left-hand thread)!
Page 10
Notice! The bearing carrier can be cleaned manually with water� Do NOT put it into water or a dishwasher for cleaning!
/// Ordering spare parts When ordering spare parts, please indicate: › Vessel type� › Item and designation of the spare part, /// Exchanging and replacing the blending tool The blending tool can be disassembled (see section “Cleaning“)� When changing the blending tool directly after a blending procedure, the blending tool is hot! Let it cool down before handling it! Before reassembling the blending tool, make sure that all parts are clean! /// Repairs...
Technical data MultiDrive BL 2000 MultiDrive BL 2000 T Max� useful volume 2000 Max� feed grain size Blending tool material Stainless steel Part in contact with product Stainless steel PCTG PTFE Silicone Ceramic Integrated temperature / RFID sensor Max� temperature setting °C Temperature measurement Temperature measurement...