Table of Contents
Advertisement
When in the Stops screen, you can use the following commands:
Up/Down
Next
Show
Stops Actions
You can tap the Actions button for the following command options:
Set as Origin
Lets you designate the selected address as the route origin. You would
use this command when calculating a route from a point other than your
current location. Note: You are still connected to the GPS signal.
Add Stop
Lets you add a location by specifying an address from recent locations,
favorite locations, or pre-defined POIs, such as gas, food, or lodging.
Rename Stop
Lets you change the stop information, such as name, comments, or
route group.
Delete Stop
Lets you remove a selected stop.
Optimize Route
Your trip itinerary is created by the sequence of stops entered. This
may not be the most efficient route. When you click Optimize Stops,
Destinator changes the order of stops to create the most efficient route.
Information
This button displays the location's address information.
Use the Up or Down buttons to change the order of your itinerary.
Shows the stop destination on the map and lets you select a route
type, Quick or Short. Tap Go to calculate the stop destination.
Select the Show button to view the selected stop destination on
the map.
Advertisement
Table of Contents
