Arbor Replacement - WEISS VM18L Operator's Manual

!
T
his machine is designed and intended for use by
properly trained and experienced personnel only! If
you are not familiar with the proper and safe use of
mill/drills, don't use the machine until proper
training and knowledge have been obtained!
Failure to comply may cause serious injury!

Arbor Replacement

1. Disconnect machine from the power source,
unplug.
2. Remover the cover of drawbar onto the motor
cover (A, Fig, 14).
3. Hold the flat of spindle (B, Fig.15) to keep it from
moving while loosening the drawbar (C, Fig 16)
with the Crescent spanner in toolbox.
4. Loosen the drawbar approximately three to four
full turns.
5. Tap the drawbar head with a rubber mallet to
dislodge the arbor.
6. Grasp the arbor with on hand while loosening the
drawbar with the other. Continue to loosen the
drawbar until the arbor can be withdrawn from
the spindle. Wipe out the spindle with a clean dry
rag.
7. Wipe down the new arbor with a clean dry rag
and place the arbor into the spindle. Thread the
drawbar into the arbor. Tighten the drawbar with
a spanner while holding the spindle.
Do not loosen the drawbar more than three or
four turns before hitting with a rubber mallet.
Damage to the drawbar threads may occur!
WARNING!
WARNING!
10
Fig. 14
B
Fig. 15
C
Fig. 16