Electrical Connections; Brushless Motor; Magnetic Switch; Speed Control Knob - WEISS VM18L Operator's Manual

ELECTRICAL CONNECTIONS

WARNING!
A qualified electrician must make all electrical
connections!
Failure to do so may cause serious injury!
Before connecting the machine to the mains, make sure
that the electrical values of the mains supply are the
same as those for the machine's electrical components.
Use the wiring diagram (Fig. 11) for connecting the lathe
to the mains supply.
WARNING!
Make sure the machine is properly ground!
Failure to do so may cause serious injury and
damage to user!

Brushless Motor

Model 80BL-5550, 110V, 1HP
Make sure that all 2 phase (L, N) are connected.
Defective or incorrect connection will render the
guarantee null and void.
Indicators are:
Motor runs hot immediately (3-4 minutes).
Motor doesn't run silently and has no power.
Magnetic Switch (A, Fig.12) has the function of
emergency stopping and the protective function to the
machine and electric components. Green push button
marked "I" to start the motor, Red push button marked
"O" to switch the motor off.
Speed Control Knob (B, Fig. 12) turn it clockwise to
increase the spindle speed, reverse to decrease. The
knob should be turned to zero each time the machine
is stopped. Always start the machine with the knob
set at zero.
F/R switch (C, Fig.12) changing the position of switch
will reverse the direction of the motor. F-forward
direction, R- reverse direction.
Fuse Base (D, Fig. 13) located on the back plate of
electrical box. Fuse what rate is 8A is put in the base.
Turn counter-clockwise the button to open and
change the fuse, reverse to retighten.
9
Fig.11
Fig.12
D
Fig.13