Electro-Metrics RVR-30M Instruction Manual

Vertical antenna, 9 khz – 30 mhz

Advertisement

Quick Links

INSTRUCTION MANUAL
VERTICAL ANTENNA
MODEL RVR-30M
9 kHz – 30 MHz

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RVR-30M and is the answer not in the manual?

Questions and answers

Summary of Contents for Electro-Metrics RVR-30M

  • Page 1 INSTRUCTION MANUAL VERTICAL ANTENNA MODEL RVR-30M 9 kHz – 30 MHz...
  • Page 2 INSTRUCTION MANUAL THIS INSTRUCTION MANUAL AND ITS ASSOCIATED INFORMATION PROPRIETARY. UNAUTHORIZED REPRODUCTION IS FORBIDDEN.  1995 ELECTRO-METRICS CORP. VERTICAL ANTENNA 9 kHz – 30 MHz ELECTRO-METRICS MODEL RVR-30M SERIAL NO: N/A ELECTRO-METRICS CORPORATION 231 Enterprise Road, Johnstown, New York 12095...
  • Page 3 WARRANTY This Model RVR-30M Vertical Antenna is warranted for a period of 12 months (USA only) from date of shipment against defective materials and workmanship. This warranty is limited to the repair of or replacement of defective parts and is void if unauthorized repair or modification is attempted.
  • Page 4 EMC-30 Interference Analyzer, it can be used with any equivalent 50-ohm receiver/analyzer being designed and calibrated for use in a 50-ohm system. The Model RVR-30M is designed for use in conjunction with the Model GPA-30 Counterpoise, Model TRI-136 Tripod, and Model CAC-30 Coaxial Cable.
  • Page 5 50-ohm instrument. 4.0 Theory Of Operation The Model RVR-30M Vertical Antenna, is basically a 1-meter (41-inch) rod. As is the case with any rod antenna, optimum transfer of an intercepted signal to the receiver using 50- ohm cable requires that the rod be fed to an impedance transformation network. Since it is...
  • Page 6 6.0 Electric Field Measurements 6.1 Narrowband Radiated Signals With the Model RVR-30M Remote Vertical Antenna, connected to the 50-ohm receiver, as described above, tune the receiver to the frequency of interest. Read the two-terminal voltage indicated by the receiver for the particular signal of interest, following the calibration and operating procedures in the instruction manual of the receiver.
  • Page 7 ELECTRO-METRICS RVR-30M VERTICAL ANTENNA To convert the resulting two-terminal reading to the appropriate field strength when using the RVR-30M, simply add the "antenna factor in dB" at the frequency of interest from the Antenna Factor Chart for the antenna being used.
  • Page 8 ELECTRO-METRICS RVR-30M VERTICAL ANTENNA FIGURE 1 ANTENNA FACTOR CHART RVR-30M VERTICAL ANTENNA PAGE 5A (RVR30M-5)

Table of Contents