Sony SRS-X9 Service Manual page 27

3. Destination display
The check of the destination can be performed.
Procedure:
1. While entering the any fi rmware version display mode, press
the [WPS] button.
2. Destination is shown by the frequency of blinking of [LINK]
LED.
The number of times
Destination
of blinking
US, Canadian and Taiwan
1
models
Except US, Canadian and
2
Taiwan models
4. Releasing method
Touch the [?/1] button to turn the power off.
WIRELESS LAN RF RECEPTION LEVEL DISPLAY
MODE
The receiving level at the time of wireless LAN connection can
be checked.
Necessary Equipment:
• Access point supporting WPS
Procedure:
1. Touch the [?/1] button to turn the power on. Check that the
[LINK] LED is turns off.
2. Touch the [NETWORK] button to select the network function.
3. Press and hold the [WPS] button, the beep sound occurs, the
[LINK] LED is green blinking.
4. Press the [WPS] key on the access point.
5. Wireless LAN connection is completed. Check that the [LINK]
LED is green lights up.
6. Touch and hold the [NETWORK] button, the beep sound oc-
curs, and enter the wireless LAN RF reception level mode.
LED which shows a receiving level blinks.
Function LED
Reception
NET-
level
USB-A
WORK PAIRING
0 % OFF OFF OFF
0 < 20 % Blinking OFF OFF
20 < 40 % Blinking Blinking OFF
40 < 60 % Blinking Blinking Blinking OFF
60 < 80 % Blinking Blinking Blinking Blinking OFF
80 < 100 % Blinking Blinking Blinking Blinking Blinking
Off or blinking
Releasing method:
Touch the any button.
SRS-X9
ALL LED LIGHTS ON MODE
Lighting of all the LED can be checked.
Procedure:
1. Touch the [?/1] button to turn the power on.
2. Touch the two buttons of [UPDATE] and [NETWORK] simul-
taneously.
Touch (UPDATE button is not displayed)
3. Touch the [ PAIRING] t [VOL –] t [VOL +] button in
order (in less than 3 seconds).
4. Enter the all LED lights on mode. All LED and back-light are
lights up.
(LED with two or more colors is lights up an orange)
Releasing method:
Touch the [?/1] button to turn the power off.
ALL RESET MODE
All information on the unit can be initialized.
Procedure:
1. Touch the [?/1] button to turn the power on.
2. Touch and hold the two buttons of [?/1] and [VOL –] simulta-
neously.
3. The [?/1] LED is blinking, and initialization is completed.
Then turn the power off.
AUDIO
USB-B
IN
OFF OFF
OFF OFF
OFF OFF
OFF
27 27
SRS-X9
Ver. 1.1