HP HPE 4200 Series Installation Manual page 7

9/18/2020
Item Number
1
Figure 7: Attaching brackets to a 5U chassis
Item Number
1
2. Partially install a screw (5/8 in number 12-24) into the top hole of a pairof holes that are 0.5 in apart in each rack/cabinet upright
as shownin the illustration below. Ensure that the screws are at the same level ineach upright.
Figure 8: Partially installed screw for bracket notch
Item Number
1
3. Place the switch in the rack and lower it so the notches in the bottom of the bracket slide onto the screws, then tighten these
screws.
Figure 9: Setting the bracket notch
HPE 4200 vl Switch Series - Installation
Description
Partially install a screw into the top hole of aclose (0.5 in) pair on both sides of the rack
Description
10 mm M4 screws
Description
10 mm M4 screws
7/12