ADJ Mega Bar 50RGB RC User Manual page 10

Mega Bar 50RGB RC
Color Change Mode:
In this mode the Mega Bar 50RGB RC will change through the different colors.
1. Plug the fixture in and press the MODE button until "JP.XX" is displayed. "XX" is a number from
01-99, which represents the adjustable rate of the speed change.
2. Press the UP or DOWN buttons to adjust the speed of the color change.
Color Fade Mode:
In this mode the Mega Bar 50RGB RC will fade in and out of the different colors.
1. Plug the fixture in and press the MODE button until "Fd.XX" is displayed. "XX" is a number from
01-99, which represents the adjustable rate of the speed change.
2. Press the UP or DOWN buttons to adjust the speed of the color change.
Auto Mode:
1. Plug in the fixture and press the MODE buttons until "AUTO" is displayed. You are now in AUTO
mode, and the fixture will cycle through the color change and color fade.
Sound Active Mode:
In this mode the Mega Bar 50RGB RC will react to sound, and chase through the different colors.
1. Plug the fixture in and press the MODE button until "SO.XX" is displayed. The fixture will now
change color in response to sound.
2. You can press the UP or DOWN buttons to adjust the sound sensitivity level. The level can be
adjusted from "SO.00" (least sensitive) to "SO.31" (most sensitive).
RGB Mode:
In this mode you can select either red, green, blue, or adjust the colors to create a custom color,
which will remain static. You can adjust the intensity of each color to create the desired result.
1. Plug the fixture in and press the MODE button until "drGb" is displayed, then press SETUP.
2. You can press the UP or DOWN buttons to adjust the intensity of the displayed color. When you
have adjusted your desired color press SETUP to scroll to the next color.
DMX Mode:
There are seven DMX Modes to choose from: 1 Channel, 2 Channel, 3 Channel, 4 Channel, 5
Channel, 6 Channel, or 7 Channel. Operating through a DMX controller gives the user the freedom to
create custom programs tailored to his or her own individual needs.
1. To run your fixture in DMX mode, connect your fixture to a standard DMX 512 controller via the
XLR connections on the fixture and the controller.
2. Press the MODE button until "d.XXX" is displayed. Press the UP or DOWN buttons to select
your desired address. Once you have set your desired DMX address, press the SETUP button to
choose your desired DMX mode.
3. When you press the SETUP button "CH-X" should be displayed. "X" represents the DMX
Channel mode. Press the UP or DOWN buttons to select your desired DMX Channel mode, and
press the SETUP button again once you have found your desired DMX Channel mode. Please
see the DMX Values & Traits sections of this manual for details.
ADJ Products, LLC - www.adj.com - Mega Bar 50RGB RC User Manual Page 10
Operating Instructions