Humminbird Trolling Motor Transducer Installation Manual page 2

TROLLING MOTOR TRANSDUCER Installation Guide
5. Select a 2D Sonar View to display on-screen.
If the bottom is visible on-screen with a digital depth readout, the transducer is working
properly.
6. Power Off: Press and hold the POWER key.
7. Remove the transducer from the water.
8. Disconnect the transducer cable from the control head.
2
| Mount the Transducer on the Trolling Motor
WARNING! Disconnect the trolling motor from all sources of electrical power before you start the
installation.
WARNING! Confirm that the trolling motor is properly secured to the boat and will not shift during
the installation.
1. Position the transducer on the underside of the motor housing.
Refer to the illustration that most resembles your accessory, noting any requirements for
directional bias.
NOTE: Round, circular-bottomed transducers have no directional bias, and therefore
orientation of these types of transducers is not as important. Rounded rectangular
transducers, however, do have a directional bias, and must be installed as shown in the
illustration.
NOTE: The transducers shown
below have no directional bias.
The transducer should be mounted forward of the motor shaft. Styles of transducer may differ
from the illustrations.
2. Insert the hose clamp through both openings on the top of the transducer and pull the two
ends up around the motor housing.
As you hand-tighten the hose clamp, check to make sure that the transducer is properly
aligned with the motor housing. Hand-tighten only!
3. After tightening the hose clamp, confirm that the transducer is securely attached to the motor
housing and will not slip off while in operation.
Attaching the Transducer
NOTE: The transducer shown below has a
directional bias, and therefore needs to be
oriented according to the illustration below.
cable slots
temp probe
2
530511-8_A
Side View of the Transducer