Installation; Prior To Connecting - Whirlpool AMW 730/NB Manual

INSTALLING THE APPLIANCE

PRIOR TO CONNECTING

C C
HECK THAT THE VOLTAGE
ing plate corresponds to the
voltage in your home.
D
O NOT REMOVE THE
MICROWAVE INLET PRO
lo-
TECTION PLATES
cated on the side
of the oven cavi-
ty wall. They pre-
vent grease and food particles
from entering the microwave in-
let channels.
M
that the oven cavity is
AKE SURE
empty before installing.
M
AKE SURE THAT THE APPLIANCE IS NOT
. Check that the oven
DAMAGED
door closes firmly against the
door support and that the inter-
nal door seal is not damaged.
Empty the oven and clean the in-
terior with a soft, damp cloth.

INSTALLATION

F
OLLOW THE
tions provided when installing the appli-
ance.
D D
on the rat- th t
has a damaged power cord or
plug, if it is not working prop-
erly, or if it has been damaged
or dropped. Do not immerse
-
the power cord or plug in wa-
ter. Keep the cord away from hot
surfaces. Risk of electrical shock,
fire or other hazards.
T
enough to connect the appli-
ance to the mains power supply
once it is fitted inside the hous-
ing.
F
current safety regulations, an all-
pole disconnect switch with a
minimum contact gap of 3 mm
must be used.
separate installation instruc-
O NOT OPERATE THIS APPLIANCE
I
F THE POWER CORD IS TOO SHORT
have a qualified electrician
or service technician install
an outlet near the appli-
ance.
must be long
HE POWER CORD
to comply with
OR INSTALLATION
EN
if it
,
29