Asko W6231 Use And Care Manual page 19

5. Pull the handle and the door will open.
6. Insert the handle into its slot and screw it
into place. Close the drain pump cover.
If the door still cannot be opened in the nor-
mal way on future occasions, you should call
the service department.
MACHINE WILL NOT TAKE IN WATER AFTER STAR-
TING
- Check that the water tap is open.
Proceed as follows:
1. Open the water tap.
2. If the program started more than five minu-
tes ago, restart the program with the
ton.
- Check that the strainer in the machine's wa-
ter inlet is not clogged.
Proceed as follows:
1. Close the water tap.
2. Unscrew the hose to the machine's water
inlet.
3. Clean the strainer in the machine's inlet val-
ve.
4. Screw the hose back in place.
5. Open the water tap.
6. If the program started more than five minu-
tes ago, restart the program with the
ton.
If this does not help, call the service department.
MACHINE WILL NOT SPIN
- Is (No spin) selected?
The machine has completed the program wit-
hout spinning.
Switch off
suitable spin speed.
- Check for any unbalance in the load.
The machine has an integral unbalance sensor,
which causes the speed to be reduced or spin-
ning to be bypassed if high unbalance is present
in the load. The machine performs all the rinse
sequences, however.
Proceed as follows:
1. Open the door and redistribute the load.
2. Run the Spin program at a suitable speed.
WATER REMAINS IN THE MACHINE AT THE END
OF THE PROGRAM
- Is the
in?
but-
The machine has completed the program wit-
hout spinning and does not pump out the water
at the end of the program.
Switch off
Spin programs (at a suitable speed) to remove
the water.
- Is the power supply switched off?
If so, the machine will have stopped in the pro-
gram. Check the fuses in the house. The pro-
gram will continue when the power supply re-
turns.
but-
and run the Spin program at a
button (No Spin/No Drain) pressed
and run either of the Drain or
19