Advertisement
3. OPERATION
3.1.
To use the meter; connect the earth clip to a source of ground such as a ground wire, vehicle frame or the negative terminal of the
battery.
3.2.
Fit the appropriate probe or clip to the meter and connect to the wire, socket etc. under test; the backlight on the LCD display will light
and the voltmeter will display any voltage present.
3.3.
If no voltage is present, confirm that the earth clip has a good ground.
3.4.
If the meter still does not operate check the lamp on a known good source such as a battery.
3.5.
Having confirmed the meter is working correctly; test the wire, socket etc. under test again, if you still have no reading the wire is dead.
3.6.
Consult the vehicle handbook for fuse positions and check if the fuse has blown. If the fuse has blown, first establish the reason for the
fuse blowing before replacing with the same fuse type.
3.7.
If the fuse is good then work back along the test wire, socket etc. towards the fuse until you find a point where it is live. This way you
can narrow down where the open circuit, break or bad connection is.
3.8.
Note: You may use the probes to pierce the wire's insulation to allow you to test closer to the open circuit, break or bad
connection.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
01284 703534
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
PP5 Issue: 1 - 29/11/18
Advertisement
