ACU-RITE MILL-PWR G2 Software Update page 2

Procedure for downloading the update files and placing them on a USB drive.
Download the update from
Controls Tab.

Unzip the downloaded archive insuring the target is the root level of your USB drive.

Insure the files setup.zip and setup.ini are transferred to a folder at the root level of your
USB drive named install, //MY USB DRIVE/install/
Procedure for updating the software

Shut down the control software using the normal method of pressing the Shutdown soft
key and then confirming the shutdown by pressing Yes.

Wait for the screen message which indicates that it is safe to switch off power, or restart.

Insert the USB memory device containing the folder named "install" on the USB memory
device.

Press ENTER to restart the system.

The software update will now be done automatically, taking approximately 10 - 20
minutes.
! A confirmation box will appear. If necessary, use the LEFT or RIGHT ARROW keys to select
Yes and then press ENTER.
When the update is complete, it will prompt you to remove the USB drive and restart. At this
time, remove the USB drive and press ENTER to restart. If the USB memory stick used for
installation is not removed, then the prompt to install the software will continue to appear on
subsequent power cycles.
! After installation and upon restart, you may receive a message prompt to confirm a firmware
update, accept the changes and RUN UPDATE.
- (Note: This particular NC startup screen can take several minutes to display. Please be
patient. Do not shutdown control and reboot.)
After the system has restarted, it will start up normally to the control software.
- Confirm that your count directions are correct.
upgrading software.)
- If special machine functions were active, Press the SETUP hard key, then the "Install
Setup" soft key, enter passcode 8891, press ENTER
- In the "Installation" dialogue, arrow down to the last option "Machine Functions" and
press ENTER
- Configure the dialog to match your machine Note:(only required if special machine
function options are installed like demo, AMI, guards, etc.)
- Press the USE hard key, then press the "Save Changes" soft key
http://www.acu-rite.com/software-updates.html found under the
(These values should not change when