The Asantétalk, An Ethernet Hub/Switch, And One Printer - Asante AsanteTalk User Manual

8. Go to the AppleTalk control panel of the Mac. Make sure it is
set to "connect via Ethernet."
9. On the AsantéTalk, the power and "LI" LEDs should now be lit.
10. Go to the "Chooser" in the Mac. Select the appropriate Apple-
Talk driver for your printer. The window to the right should then
show your printer. For questions regarding which driver should
be selected, please contact your printer's manufacturer.
11. Proceed with printer setup as outlined by the printer's manufac-
turer.
The AsantéTalk, an Ethernet hub/switch, and one printer
Follow the steps below to configure the AsantéTalk, an Ethernet
hub or switch, and one printer:
1. Plug AsantéTalk into the Ethernet hub/switch with the SILVER
Ethernet cable.
2. Power up a Mac that is also connected to the Ethernet hub/
switch.
3. Go to the AppleTalk control panel of the Mac. Make sure it is
set to "connect via Ethernet."
4. Connect the printer to the AsantéTalk using either the din-8 to
din-8 cable or LocalTalk connectors as described in item num-
ber 5 above.
5. Power up the printer. Wait until printer is completely warmed up
and ready to print.
6. Connect the printer to the AsantéTalk using either the din-8-
din-8 cable or LocalTalk connectors as described above.
7. Plug the power transformer into the AsantéTalk.
8. Wait 30 seconds.
9. On the AsantéTalk, the power and "LI" LEDs should now be lit.
10. Go to the "Chooser" in the Mac. Select the appropriate Apple-
Talk driver for your printer. The window to the right should then
show your printer. For questions regarding which driver should
be selected, please contact your printer's manufacturer.
11. Proceed with printer setup as outlined by the printer's manufac-
turer.
28
AsantéTalk Ethernet to LocalTalk Converter