Arturia CS-80V User Manual page 27

The sound of single 1 is «deeper» as a result of the detuning of the 4 voices and
«widened» as a result of the pan position settings between all of the voices. The result is
a very rich bass sound.
The fifth Single placed in zone 2 doesn't change. It will play a polyphonic accompaniment
sound. Let's go directly to the sixth:
Activate the ring modulator on this Single to obtain a bell sound that will be played on
the third zone.
Next lower the «Modulation» knob in order to mix the level of the ring modulator with
the «raw» sound of the Single.
After this, place the fourth zone to unison «UniLast» to obtain a monophonic lead
sound.
Lightly detune voices 7 and 8.
«Separate» the pan position of these 2 voices to the right and to the left.
To quickly «isolate» a voice (where the «edit» button is lit) and play it across the whole keyboard, use the
«solo/close» button above and to the left of the Multi panel.
If you wish to preserve CPU power, avoid using the «rotate» mode, place the zone on «ReAssign» mode.
For each of the 8 voices, you can set:
The choice of zone (from 1 to 4 or no zone)
Transposition (in semitones)
Fine tuning
Volume
Pan position
Portamento/Glissando
Ring modulator
Chorus and delay effects
For the 4 zones:
ARTURIA – CS-80V – USER'S MANUAL
Activation of the Ring Modulator
Setting the Ring Modulator
The Multi mode settings for preset «split1»
27