Arturia CS-80V User Manual page 20

Choose the «SUB BANK» called «Brass» and finally select «Brass1» among the
«PRESETS».
The CS-80V is shipped with 400 presets, which will allow you to get to know the sounds
of the synthesizer. A bank called «User / Temp» proposes a selection of presets which
allow you to work from a basic template when programming a sound.
(The sound «1 voice», for example, is presented with a single active synthesis line: an
oscillator is directed to the low-pass filter, the signal is then routed towards the VCA.)
It is also possible to visualize the totality of presets corresponding to a type of sub-bank by choosing the option
«All» in the bank. For example, to see all bass presets, click on «All»in the bank selections and then on «Bass».
3.1.1 Modifying this preset
For this, we'll begin with a simple manipulation.
Modify the brilliance of the «Brass 1» sound with the «Brilliance» controller on the
synthesizer. For this, increase or decrease the green linear «brill» knob on the control
panel (above the virtual keyboard). The tone of the sound will become more or less
«brilliant». Set this knob to your convenience.
In the same manner, you can change the range of the oscillator by decreasing the
linear «Feet I» knob to one of the 6 values expressed in «Feet» (like organs). The
lower the number, the higher the pitch. (The standard tuning can be found at the
value 8')
With these first settings, you have already modified the preset «1 voice». You can now
save the sound that you have just created.
To save a user preset («user»), click on the save icon in the tool bar: The settings of
the current sound will be saved in the preset being used without changing its name.
If the current preset is a «factory» preset, the factory preset will not be replaced.
20
ARTURIA – CS-80V – USER'S MANUAL
Select the preset brass1
Change the brilliance of the sound