Olimpia electronics POWER LIGHT Series Manual

``POWER LIGHT`` SERIES FOR NON MAINTAINED EMERGENCY LUMINAIRES

TECHNICAL CHARACTERISTICS

OPERATION VOLTAGE
MAXIMUM POWER CONSUMPTION
BATTERY (Pb)
BATTERY PROTECTION
INDICATIONS - CONTROLS
CHARGING TIME
MINIMUM AUTONOMOUS DURATION
LIGHT SOURCE
EMERGENCY ILLUMINATION
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
CONSTRUCTION MATERIALS
EXTERNAL DIMENSIONS
TYPICAL WEIGHT
GUARANTEE
GENERAL
These luminaires are used indoors (ta 40 C)
where emergency light is needed. Each
luminaire must be permanently connected to
mains power supply. In normal operation the
power and charge indicators are on to
indicate that the batteries are charging. In
case of a mains power supply failure the
power and the charge indicators turns off and
the luminaire will
automatically in emergency mode. When the
mains power supply is restored the device
turns to normal operation.
INSTALLATION
To install the luminaire follow the installation
instructions οn page 3.
OPERATION
When the device is powered from the mains
and the battery(ies) is (are) connected, the
'power' and 'charge' indicators are ON. The
'charge' indicator
charging operation. If it does not light,
probably, the batteries are disconnected. If it
does not light
connected, then contact the technician. The
power indicator
connection to the mains. The TEST button,
Page 1 from 3
EN 60598-1, EN 60598-2-22, ΕΝ 55015, ΕΝ 61547, ΕΝ 61000-3-2, ΕΝ 61000-3-3
Thank you for your trust in our products
Olympia Electronics - European manufacturer
light the spot lamps
indicates the battery
and the batteries
confirms the proper
(for LED MODULE Specifications see page 2)
GRL-21/H/90
220-240V AC/50-60Hz
13.3W/14VA
12V/7Ah
From overcharge and deep discharge
Power indicator, battery charge indicator, TEST button
90 min
White power LEDs
3200lm
5 to 40 C
Up to 95%
Aluminum, ABS/PC, PC
302 x 94 x 350 mm.
4100gr.
3 years (1 year for the battery)
has a dual use. If pressed instantlly while the
o
device is connected to the mains, the device
simulates the power interruption, by lighting
the lamps for 3''. In that way, we can control
the driver circuit of the lamps and the lamps as
indicated in paragraph 3 in the text below.
DIMMING OPTION
When the luminaire is in emergency mode, with
corresponding pressings of the button, we can
choose the illumination of 100%, 50%, 33% or
turned off, in order to increase the autonomy
duration. This option is canceled when the
network is restored.
ΑΤΤΕΝΤΙΟΝ!!!
1. Operations for installation, maintainance or
testing must be done by authorized
personnel only.
2. The device must be connected to the
mains power supply through a fuse
dependent by the total amount of the line's
power load.
3. It is suggested to check every month the
indication LED for battery charging, and by
are
pushing instantly the TEST button to check
the emergency circuit and the lamps. If the
luminaire does not light,
GRL-21/H/180
2x12V/7Ah
24h
180 min
IP42
o
6300gr.
contact the
923021042_09_004