Starting A Measurement - Lakeshore Measure Ready FastHall M91 Quick Start Manual

Startup
Connection
The M91 is powered on by plugging in the power supply.
The instrument powers up in the power up state with the
output disabled. The instrument should be powered on
for 30 minutes before using for rated specifications.
NOTE: No measurements can be started from the
front panel screen; it is used only to display high-level
measurement results.
9
https://www.lakeshore.com/m91/

Starting a Measurement

The MeasureReady® M91 FastHall™ measurement
controller executes the following measurements: contact
check, resistivity, and Hall measurement. Each time
a new measurement is run, it overwrites the existing
measurement data of its type (a contact check will
overwrite a contact check, but will not overwrite a
resistivity measurement). Cycling power or resetting the
instrument will clear all data.
Optimization
The M91 is able to optimize your sample setup
parameters, which can be used in all of your
measurements. Optimization allows the user to rapidly
find the proper excitation for a sample without a lengthy
trial and error process.
MeasureReady® M91 FastHall™ Measurement Controller Quick Start Guide