Maintenance And Care; Servicing Guidelines - Yamabiko ECHO MTA-TB Operator's Manual

Observe the following precautions when checking and maintaining your product after use:
 Turn the engine off and do not attempt to check or maintain the product until the engine has cooled.
You could burn yourself.
 Remove the spark plug cap before performing checks and maintenance.
An accident could occur if the product starts unexpectedly.
 Checking and maintenance requires specialist knowledge. If you are unable to check and maintain the product or deal with a
fault yourself, consult your dealer. Do not attempt to dismantle the product.
 For spare parts and consumables, please use only genuine parts and designated products and components. Using parts from
other manufacturers or non-designated components may result in a malfunction.

Servicing guidelines

Area
Drive shaft
Angle transmission
Cut off knife
Screws, bolts and nuts
* Or 25 hours, whichever occurs first. ** Or 50 hours, whichever occurs first.
 Time intervals are maximum. Actual use and your experience will determine the frequency of required maintenance.

Maintenance and care

If you have any questions or problems, please contact your dealer.
Lubricating drive shaft
Angle transmission
IMPORTANT
Maintenance
Grease
Grease
Inspect/Clean
Inspect, Tighten/Replace
IMPORTANT
Maintenance and care
Maintenance and care
WARNING
Page
15
15
-
-
Inspect the drive shaft (A) every 25 hours of use and replenish
grease if it is insufficient.
NOTE
Use good quality lithium multi grease.
1. Remove the plug (A) and drain screw (B) from the angle
transmission (C).
2. Add grease into the transmission until old grease is pushed
out. If necessary, use a low pressure pump.
 Use good quality lithium multi grease.
3. Reinstall the drain screw and plug.
15
Before use
•
•
NOTE
Monthly
•*
•**